Trailer Hitch Installation for 2014 Jeep Wrangler (VIDEO)

Share |

Welcome to the installation video of the CURT 31432 Front Mount Hitch on the 2014 Jeep Wrangler. To give you a better view of the installation, we are using a lift. Like most installations, this vehicle does not need to be elevated for the install. We estimate this installation to take 45 minutes to an hour and a half depending on your level of expertise.

These are the tools necessary for the install: Flathead Screwdriver, 19mm Socket, Ratchet Extension, Torque Wrench. Begin by removing six plastic screw fasteners, located here. We will be removing the undercarriage deflector from the vehicle. Raise the hitch into position and align the holes in the frame with the holes in the hitch.

On the passenger’s side, fasten the hitch to the bottom of the bumper at the rearmost attachment tabs using the supplied hex bolts and hex flange nuts. Repeat this process on the driver’s side attachment point. Fasten hand tight. Fish wire the lower passenger’s side attachment points by inserting the coiled end of the fish wire through the hitch and through the frame attachment point and out through the lower access hole. Place the square holed spacer over the coiled end of the fish wire and insert the spacer into the access hole. Thread the carriage bolt into the coiled end of the fish wire and insert the carriage bolt into the frame access hole. Pull on the opposite side of the fish wire, allowing the carriage bolt to pass through the square hole spacer, the frame attachment point, and out through the hitch. Carefully remove the fish wire, as it will be used again. Fasten the hardware with a hex flange nut. Repeat this process on the opposite attachment point on the driver’s side. Fasten the remaining attachment points by using the supplied handle nuts. Bend the handle nuts slightly for ease of installation and insert the handle nut into the access hole in the bumper. Insert the hex bolt and conical tooth washer through the remaining attachment point on the passenger’s side and fasten it to the handle nut.

Repeat this process on the opposite attachment point on the driver’s side. Torque all hardware to the exact value specified in the supplied instruction sheet.

This completes the installation of the CURT 31432 Front Mount Trailer Hitch on the 2014 Jeep Wrangler. Check out all the CURT products for your Jeep, including heavy-duty cargo carriers. Thank you for watching this video and now you can bring it. to U-Haul, the first name in towing products.

Find Rear Mounted Trailer Hitch for 2014 Jeep Wrangler Rubicon 4 Wheel Drive